Adhesive for Neoprene CM-233

• Suitable for Hypalon Neopren and rubber accesories.
• No heating is required for its process and curing.
• Dries with the addition of the Desmodur catalyst.

Instructions for use: Treat the surfaces with sandpaper (P80-100) and thoroughly clean with acetone or MEK. Mix glue with Desmodur RC or RFE catalyst in a ratio of 8-10% (80-100gr per kilo). Apply with a brush a thin coat on the surfaces to be bonded without contacting them. Wait 4-12 hours for the glue to set and then spread another layer on. Wait for about 10 minutes for the solvents to evaporate and then join the parts. Immediately after, press thoroughly and apply constant pressure for at least 12 hours.

The curing process is completed within 48 hours.